GS748T Software User Manual
Configuring the Switch 4-17
v2.0, April 2007
To set up RSTP:
1. From the main Navigation Pane menu, select:
Switch
→ Advanced → Spanning Tree; The IEEE 802.1W RSTP Setting page shown in
The following screen is displayed. with a table of port numbers that can be set as enabled or
disabled.
2. Select Enable (RSTP is disabled by default).
3. Modify the page settings if required, or accept the defaults.
4. Click Apply to save your settings.
Figure 4-15
To Next Page
Loading...
