Page 14 of 24
CHAPTER 3: INSTALLATION
This chapter describes the installation procedures for your NETGEAR Model GSM7328S ProSafe 24+4
Gigabit Ethernet L3 Managed Stackable Switch. Switch installation involves the following steps:
Step 1: Preparing the site
Step 2: Installing the switch
Step 3: Checking the installation
Step 4: Applying AC power
Step 5: Connecting devices to the switch
Step 6: Installing a SFP module
Step 7: Connecting to the console port to manage the switch for initial configuration
Step 8: Installing AX741 10-Gigabit Ethernet XFP Adapter Modules
Step 9: Installing AX742 24-Gigabit Stacking Modules
Step 10: Connecting to RPS Modules
Step 1: Preparing the Site
Before you install your switch, be sure your operating environment meets the operating environment
requirements in Table 3-1.
Table 3-1. Site Requirements
Characteristics Requirements
Mounting
Desktop installations:
Rack-mount
installations:
Provide a flat table or shelf surface.
Use a 19-inch (48.3-centimeter) EIA standard equipment rack that is grounded
and physically secure. You also need the rack-mount kit supplied with your
switch.
Access
Locate the switch in a position that lets you access the front panel RJ-45 ports,
view the front panel LEDs, and access the rear-panel power connector.
Power source
Provide a power source within 6 feet (1.8 meters) of the installation location.
Power specifications for the switch is shown in Appendix C. Be sure the AC
outlet is not controlled by a wall switch, which can accidentally turn off power
to the outlet and the switch.
Environmental
Temperature: Install the switch in a dry area, with ambient temperature between 0 and 40ºC
(32 and 104ºF). Keep the switch away from heat sources such as direct
sunlight, warm air exhausts, hot-air vents, and heaters.
Operating humidity: The installation location should have a maximum relative humidity of 90%,
non-condensing.
To Next Page
Loading...
