32
Configuring WEP Encryption Security
The MA101 USB Adapter allows you to restrict access to your wireless network
based on WEP keywords. Following the steps below to perform this procedure.
1. Run the Configuration Utility and select the Security tab page.
Figure 3-2: Configuring WEP Encryption
2. Select the WEP encryption strength you will use. The characters are case
sensitive. Use the same values when configuring other wireless devices that
will communicate with this wireless USB adapter.
• 40/64-bit WEP data encryption
• 128-bit WEP data encryption
Note: A larger encryption key requires more processing to encode/decode
the messages. Larger encryption key lengths may slow the
communications process response times.
3. Click Apply then OK for the changes to take effect.
To Next Page
Loading...
