Why is file transfer slow on my NETGEAR MS510TX?
Slow file transfers or degraded performance on your NETGEAR Switch can occur due to a broadcast storm caused by a network loop. To resolve this, ensure only one path exists between any two networked devices to break the loop. You can also configure the Spanning Tree Protocol (STP) via the switch's web management interface to prevent network loops.
General| Switch type | Managed |
|---|---|
| Switch layer | L2/L3/L4 |
| Quality of Service (QoS) support | Yes |
| Stackable | - |
| Product color | Gray |
| Console port | RJ-45 |
| USB 2.0 ports quantity | 1 |
| Installed SFP modules quantity | 0 |
| Basic switching RJ-45 Ethernet ports type | Gigabit Ethernet (10/100/1000) |
| Basic switching RJ-45 Ethernet ports quantity | 8 |
| Noise level | 21 dB |
| Processor frequency | 800 MHz |
| Mean time between failures (MTBF) | 1078683 h |
| 10G support | No |
| Number of VLANs | 256 |
| Networking standards | IEEE 802.1D, IEEE 802.1Q, IEEE 802.1ab, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3ae, IEEE 802.3an, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z |
| Jumbo frames | 10000 |
| Latency (10 Gbps) | 2.36 µs |
| MAC address table | 16000 entries |
| Packet buffer memory | 1.5 MB |
| AC input voltage | 100 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (max) | 26.1 W |
| Power consumption (typical) | 10.19 W |
| DHCP features | DHCP client, DHCP server |
| Access Control List (ACL) rules | 164 |
| Heat dissipation | 89.06 BTU/h |
| Operating altitude | 0 - 3000 m |
| Storage temperature (T-T) | -20 - 70 °C |
| Operating temperature (T-T) | 0 - 50 °C |
| Storage relative humidity (H-H) | 0 - 95 % |
| Operating relative humidity (H-H) | 0 - 90 % |
| Multicast MAC address table | 512 entries |
Weight and Dimensions| Depth | 169 mm |
|---|---|
| Width | 328 mm |
| Height | 43 mm |
| Weight | 1420 g |
To Next Page
