NETGEAR Nighthawk CM3000 User Manual

3. Enter the admin user name and password.
The user name is admin. The default password is printed on the product label. The
user name and password are case-sensitive.
The BASIC Home page displays.
4. Click the ADVANCED tab.
The ADVANCED Home page displays.
5. Click the Reboot button.
A confirmation message displays.
6. Click the OK button.
The cable modem reboots.
Reset the cable modem to factory default
settings
To reset the cable modem to factory default settings, you can use either the Reset
button on the back panel of the cable modem or the Factory reset software button.
However, if you changed the default password that you use to access the cable modem
and lost the password, you must use the Reset button on the back panel.
After you reset the cable modem to factory default settings, the password is printed on
the product label. The LAN IP address is always 192.168.100.1. You cannot change this
LAN IP address.
User Manual20Manage Your Network
Nighthawk CM3000 2.5 Gbps Cable Modem

NETGEAR Nighthawk CM3000 Specifications

General

Brand	NETGEAR
Model	Nighthawk CM3000
Category	Modem
Language	English