LAN Configuration
119
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
For the DMZ, there are two DHCPv6 server options:
• Stateless DHCPv6 server. The IPv6 clients in the DMZ generate their own IP address by
using a combination of locally available information and router advertisements, but
receive DNS server information from the DHCPv6 server. For stateless DHCPv6, you
need to configure the RADVD and advertisement prefixes (see Configure the IPv6 Router
Advertisement Daemon and Advertisement Prefixes for the DMZ on page 122).
• Stateful DHCPv6 server. The IPv6 clients in the DMZ obtain an interface IP address,
configuration information such as DNS server information, and other parameters from the
DHCPv6 server
. The IP address is a dynamic address. For stateful DHCPv6, you need to
configure IPv6 address pools (see IPv6 DMZ Address Pools on page 121).
To enable and configure the DMZ port for IPv6 traffic:
1. Select Network Configuration > DMZ Setup.
2. In the upper right of the screen, select the IPv6 radio button.
The DMZ Setup screen
displays the IPv6 settings:
Figure 65.
To Next Page
Loading...
