Firewall Protection
193
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
• Host 2 has changed its MAC address to 00:01:02:03:04:09. The packet has an IP
address that matches the IP address in the IP/MAC Bindings table but a MAC address
that does not match the MAC address in the IP/MAC Bindings table.
• Host 3 has changed its IP address to 192.168.10.15.
The packet has a MAC address that
matches the MAC address in the IP/MAC Bindings table but an IP address that does not
match the IP address in the IP/MAC Bindings table.
In this example, the VPN firewall blocks the traf
fic coming from Host 2 and Host 3, but allows
the traffic coming from Host 1 to any external network.
The total count of dropped packets is
displayed.
IPv4/MAC Bindings
To set up a binding between a MAC address and an IPv4 address:
1. Select Security > Address Filter > IP/MAC Binding
. In the upper right of the screen,
the IPv4 radio button is selected by default. The IP/MAC Binding screen displays the
IPv4 settings. (The following figure shows a binding in the IP/MAC Binding table as an
example.)
Figure 116.
2. In the Email IP/MAC Violations section of the screen, specify if you want to enable email
logs for IP/MAC binding violations. (You have to do this only once.) Select one of the
following radio buttons:
• Ye
s. IP/MAC binding violations are emailed. Click the
Firewall Logs & E-mail page
link to ensure that emailing of logs is enabled on the Firewall Logs & E-mail screen
(see Configure Logging, Alerts, and Event Notifications on page 362).
• No. IP/MAC binding violations are not emailed.
3. Click Apply to save your changes.
To Next Page
Loading...
