Introduction
22
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Note: The VPN firewall factory default IP address is 192.168.1.1. If you
change the IP address, you need to use the IP address that you
assigned to the VPN firewall to log in to the VPN firewall.
Figure 5.
Note: The first time that you remotely connect to the VPN firewall with a
browser through an SSL connection, you might get a warning
message regarding the SSL certificate. Follow the directions of your
browser to accept the SSL certificate.
3. In the User Name field, type admin. Use lowercase letters.
4. In the Password / Passcode field, type password. Here, too, use lowercase letters.
Note: The VPN firewall user name and password are not the same as any
user name or password you might use to log in to your Internet
connection.
Note: Leave the domain as it is (geardomain).
To Next Page
Loading...
