IPv4 and IPv6 Internet and WAN Settings
43
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
• Destination Network. The Internet locations (based on their IP address) or groups
that are covered by the protocol binding rule.
• Action. The Edit table button, which provides access to the Edit Protocol Binding
screen for the corresponding service.
3. Click the Add
table button below the Protocol Binding table. The
Add Protocol Binding
screen displays:
Figure 22.
4. Configure the protocol binding settings as described in the following table:
Table 6. Add Protocol Binding screen settings
Setting Description
Service From the drop-down list, select a service or application to be covered by this rule. If the
service or application does not appear in the list, you need to define it using the Services
screen (see Add Customized Services on page 177).
Local Gateway
From the drop-down list, select one of the W
AN interfaces.
Source Network The source network settings determine which computers on your network are affected by
this rule. Select one of the following options from the drop-down list:
Any All devices on your LAN.
Single address In the Start IP field, enter the IP address to which the rule is applied.
Address Range In the Start IP field and End IP field, enter the IP addresses for the
range to which the rule is applied.
Group If this option is selected, the rule is applied to the selected group.
The group can be a LAN group or an IP (LAN) group.
Note: For information about LAN groups, see Manage IPv4 Groups
and Hosts (IPv4 LAN Groups) on page 96. For information about IP
groups, see Create IP Groups on page 179.
To Next Page
Loading...
