Installation and Basic Configuration
18
ProSAFE Single Band 802.11n Wireless Access Point WN203
Test LED. The Test LED is amber. After about one minute, the Test LED turns
off.
LAN LED. The LAN LED indicates the LAN speed for the LAN port: green for
1000 Mbps or amber for 100 Mbps or 10 Mbps.
WLAN LED. The WLAN LED is blue when the wireless LAN (WLAN) is ready.
Log In to the Wireless Access Point
The default IP address of your wireless access point is 192.168.0.100. By default, the DHCP
client on the wireless access point is disabled so you can log in using the default IP address.
To log in to the wireless access point:
1. Open a web browser such as Microsoft Internet Explorer 8.0 or later, or Mozilla
Firefox 18.0 or later.
2. Connect to the wireless access point by entering its default address of 192.168.0.100
into
your browser (use http and not https).
The Login screen displays:
3. Enter the default user name of admin and the default password of password.
4. Click the Login button.
The web browser displays the basic General system settings screen under the
Configuration tab of the main menu:
To Next Page
Loading...
Need help?
General
