NETGEAR ProSAFE WN203

112
B
B. Command-Line Reference
The wireless access point can be configured through either the command-line interface (CLI), a
web browser, or a MIB browser.
The CLI allows viewing and modification of the configuration from a terminal or computer through
a Telnet or SSH connection.
Keyword Description
-------------------------------------------------------------------------------------------
|-backup-configuration --Backup configuration
|
|-config> --Configuration setting
| |-country --Country/region
| |
| |-dhcp> --DHCP server setting
| | |-dns1 --DNS1 server
| | |-dns2 --DNS2 server
| | |- gateway --Default gateway
| | |-lease --Lease time
| | |-start --Start IP address
| | |-status --Status
| | |-stop --Stop IP address
| | |-subnet --Subnet mask
| | |-vlan --VLAN id
| | |-wins1 --WINS1 server
| | |-wins2 --WINS2 server
| |
| |-hotspot> --Hotspot setting
| | |-redirect --Hotspot redirection URL
| | |-status --Hotspot status
| |
| |-ip> --Set host IP
| | |-address --Host IP address
| | |-dhcp-client --Enable dhcp client
| | |-dns --IP address of Primary DNS server
| | |-dns2 --IP address of Secondary DNS server
| | |-gateway --IP address of default gateway
| | |-subnet --IP address of Subnet mask
| |