NETGEAR ProSAFE WN203

Installation and Basic Configuration
26
ProSAFE Single Band 802.11n Wireless Access Point WN203
 To configure the 802.11b/g/n wireless settings:
1. Select Configuration > Wireless > Basic > Wireless Settings.
The basic Wireless Settings screen displays. The following figure shows the 11ng
settings.
Note: The radio wave icon ( ) displays next to the enabled wireless
mode (b, bg, or ng).
2. Select one of the following 2.4 GHz band radio buttons:
• 11b. Both 802.11n- and 802.1
1g-compliant devices can connect to the access point
because they are backward compatible.
•
11bg. 802.11n-compliant devices can connect to the access point because they are
backward compatible.
• 11ng. This is the default setting. 802.11b-compliant devices cannot connect to the
access point. If you keep the default setting, go to Step 5
.
When you change the wireless mode, the Turn Radio On check box is automatically
cleared, and all fields, buttons, and drop-down menus onscreen are masked out.
3. Turn on the radio by selecting the Turn Radio On check box.
A pop-up screen displays.