NETGEAR ProSAFE WN203

Advanced Configuration
77
ProSAFE Single Band 802.11n Wireless Access Point WN203
 To configure a point-to-point wireless network with or without client association:
1. Configure the wireless access point (AP1 on LAN Segment 1 in the previous figure) as
a point-to-point bridge:
a. Select Configuration > Wireless Bridge.
The Bridging screen displays (see the following figure).
b. Select the Enable Wireless Bridging check box.
The Local MAC
Address field is a nonconfigurable field that shows the MAC address
of the wireless access point.
c. Select the Wireless Point-to-Point Bridge radio button.
d. Click the Edit button to configure the security profile settings.
The Edit Security Profile screen displays: