NETGEAR ProSAFE WN203

Multipoint
Router
Hub or switch
bridge mode
repeating only
Multipoint
bridge mode
repeating only
Multipoint
bridge mode
repeating only
Internet
AP1
AP2
AP3
LAN segment 1
LAN segment 2
Advanced Configuration
86
ProSAFE Single Band 802.11n Wireless Access Point WN203
Figure 18. Repeating the wireless signal in point-to-multipoint bridge mode
 To configure the wireless access point to repeat the wireless signal:
1. Configure the security profiles on the wireless access point (AP2 on LAN Segment 2 in
the previous figure):
a. Select Configuration > W
ireless Bridge.
The Bridging screen displays (see the following figure).
b. Select the Enable Wireless Bridging check box.
The Local MAC Address field is a nonconfigurable field that shows the MAC address
of the wireless access point.
c. Select the Wireless Point to Multi-Point Bridge radio button.
The screen adjusts. The profile table shows four security profiles.