NETGEAR RangeMax™ Dual Band Wireless-N Router WNDR3300 User Manual
A-2 Default Configuration and Technical Specifications
v1.1, October 2008
Internet connection
MAC Address Use default hardware address
MTU Size 1500
Local network
Router LAN IP address printed on
product label (gateway IP address)
192.168.1.1
Router subnet 255.255.255.0
DHCP server Enabled
DHCP range 192.168.1.2 to 192.168.1.254
Time zone Pacific time
Time zone Daylight Saving time Disabled
Allow a registrar to configure this router Enabled
Wireless
Wireless communication Enabled
SSID names • 11N SSID: NETGEAR-DualBand-N
• 11G SSID: NETGEAR-2.4-G
Security Disabled
Broadcast SSID Enabled
Transmission speed Auto
*
Country/region United States in the US, otherwise varies by region
RF channel 6 until region selected
Operating mode • 802.11n 2.4G mode
• 802.11n 5G mode and 802.11g legacy mode at 2.4G
Data rate Best
Output power Full
Firewall
Inbound (communications coming in
from the Internet)
Disabled (bars all unsolicited requests)
Outbound (communications going out
to the Internet)
Enabled (all)
*. Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary. Network con-
ditions and environmental factors, including volume of network traffic, building materials and construction, and
network overhead, lower actual data throughput rate.
Table A-1. WNDR3300 Router Default Configuration Settings (continued)
Feature Default Setting
To Next Page
Loading...
Need help?
General
