NETGEAR RANGEMAX WNDR3300 User Manual

NETGEAR RangeMax™ Dual Band Wireless-N Router WNDR3300 User Manual
Customizing Your Network Settings 5-23
v1.1, October 2008
• Disable Wireless Client Association. Usually this check box is cleared so that the router is an
access point for wireless computers.
If this check box is selected, the router communicates wirelessly only with other APs whose
MAC addresses are listed in this screen. The router still communicates with wire-connected
LAN devices.
Setting Up the Base Station
The wireless repeating function works only in hub and spoke mode. The units cannot be daisy
chained. You must know the wireless settings for both units. You must know the MAC address of
the remote unit. First, set up the base station, and then set up the repeater.
To set up the base station:
1. Set up both units with exactly the same wireless settings (SSID, mode, channel, and security).
Note that the wireless security option must be set to None or WEP.
2. Log into the wireless router base unit, under the Advanced heading, select Wireless
Repeating Function to display the Wireless Repeating Function screen.
3. Select the Enable Wireless Repeating Function check box and the Wireless Base Station
radio button.
4. Enter the MAC address for the repeater units.
5. Click Apply to save your changes.
Figure 5-12

NETGEAR RANGEMAX WNDR3300 Specifications

General

Brand	NETGEAR
Model	WNDR3300
Device Type	Wireless Router
Wireless Standards	802.11a/b/g/n
Maximum Wireless Speed	300 Mbps
Security	WEP, WPA, WPA2
Frequency Band	2.4 GHz
Ethernet Ports	4
Antennas	2 internal antennas