•
Switch integrity. If necessary, verify the integrity of the switch by resetting it. To
reset the switch, disconnect the DC power from the switch and then reconnect the
DC power. If the problem continues, contact NETGEAR technical support. For more
information, visit the support website at netgear.com/support/.
•
Autonegotiation. The RJ-45 ports negotiate the correct duplex mode, speed, and
flow control if the device at the other end of the link supports autonegotiation. If the
device does not support autonegotiation, the switch determines only the speed
correctly, and the duplex mode defaults to half-duplex.
The Gigabit Ethernet ports negotiate speed, duplex mode, and flow control if the
attached device supports autonegotiation.
Hardware Installation Guide30Troubleshooting
S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch
To Previous Page
Loading...
Need help?
General