NETGEAR WAC120

4
a. Connect the power adapter to the access point and plug
the power adapter into an outlet.
b. Wait for the Power LED
on the front panel to light
amber and turn green.
If no LEDs are lit, press the Power On/O button on the
rear panel of the access point.
4. Connect a computer.
1 2 3 4
LEDs
The LEDs on the wireless access point light to indicate wireless
access point activity:
LED Description
Power
LED
•O. Power is o.
•Green. Power in on.
•Amber. A self-test is running. During startup the LED is amber, then
blinking green before turning steady green aer 45 seconds. If the LED is
amber or continues blinking green aer one minute, a system fault exists.
Activity
LED
•O. No ethernet trac is detected.
•Green or blinking green. Ethernet trac is detected.