NETGEAR WAG511 User Manual (English)

Other manuals for NETGEAR WAG511

Questions and Answers:

Charles ThompsonAug 11, 2025

What to do if the two LEDs are blinking alternately on NETGEAR WAG511?

K
Kyle NelsonAug 11, 2025
If the two LEDs on your NETGEAR Computer Hardware are blinking alternately, it means the Wireless PC Card isn't properly associated with any Access Point. This might be because the wireless settings on the wireless nodes don't match the Access Point's settings. Here’s what you can do: * Ensure the Access Point is powered on. * Verify that the SSID, turbo mode option, and WEP encryption settings are the same on both the Access Point and the WAB501 Wireless PC Card. * Try moving closer to the Access Point or adjusting its antenna. You might also want to place the Access Point in a higher spot for better signal reception.

Christian WilsonAug 20, 2025

Why can't I see other computers on the Ethernet side of the network with my NETGEAR WAG511?

E
Elizabeth SanchezAug 20, 2025
If you're connected to an Access Point with your NETGEAR Computer Hardware but can't see other computers on the Ethernet side, it could be a physical connection issue or a network configuration problem. First, check that the Access Point is physically connected to the Ethernet network. Also, ensure that the IP addresses and Windows networking parameters are correctly configured.