NETGEAR WAX615

12
Manage the Advanced WiFi
Features for a WiFi network
This chapter describes how you can manage the advanced WiFi features for a WiFi
network.
For information about the basic WiFi features for a WiFi network, see Manage the Basic
WiFi Features for a WiFi network on page 50.
Note: In this manual, WiFi network means the same as SSID (service set identifier or
WiFi network name) or VAP (virtual access point). That is, when we refer to a WiFi network
we mean an individual SSID or VAP.
The chapter includes the following sections:
• Set NAT mode or Bridge mode for addressing and traffic
• Enable or disable client isolation for a WiFi network
• Enable or disable URL tracking for a WiFi network
• Change the format of the DHCP offer messages in a WiFi network
• Select a MAC ACL for a WiFi network
• Set bandwidth rate limits for a WiFi network
• Configure advanced rate selection for a WiFi network
Note: If you want to change the settings of a WiFi network on the access point, use a
wired connection to avoid being disconnected when the new WiFi settings take effect.
183