Installation Guide for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
2-8 Basic Setup
For Windows 2000 & 98SE/Me Users Installing a WG311T
Install the WG311T software.
Note: Windows 2000 may require you to be
logged on with administrator rights.
a. Power on your computer, let the
operating system boot up completely,
and log in as needed.
b. Insert the Resource CD for the WG311T
into your CD-ROM drive. The CD main
page shown at the right will load.
c. Click the “Install Driver & Utility” link.
d. Follow the Smart Wizard - Install
Assistant steps, and click Finish when
done to restart your computer.
Note: If you are prompted to restart your
computer, choose instead to shut it down.
This will let you install the WG311T before
restarting. Windows will find the new
hardware and can use the software you
installed.
WG311T Resource CD
Smart Wizard - Install Assistant
To Next Page
Loading...
Need help?
General
