Router Setup Manual
1-8 Connecting the Router to the Internet
v1.0, 2006-01-17
To Configure the Router to Use Your Internet Service
1. On a computer you connected to the router, open a browser such as Internet Explorer,
Netscape Navigator, or Firefox.
The router automatically displays the NETGEAR Smart Wizard configuration assistant page.
If you cannot connect to the router, verify your computer networking setup. It should be set to
obtain both IP and DNS server addresses automatically, which is usually so. For help with this,
consult the documentation that came with your computer or see the links in Appendix B,
“Related Documents”.
2. Click Next. The wizard will assist you with configuring your router to access the Internet.
Advanced users who want to manually configure the router can select the No radio button,
enter admin and password as the user name and password when prompted, and fill in the
required information on the Basic Settings page.
3. Click Done to finish.
You are now connected to the Internet!
Figure 1-7
Note: If you do not see this page, type http://www.routerlogin.net in the browser
address bar and click Enter.