Reference Manual for the 108 Mbps Wireless Media Router WGT634U
Wireless Configuration 4-11
April 2004, 202-10018-02
3.
From the Wireless Settings menu, click the Setup Access List button to display the Wireless
Access menu shown below.
Figure 4-6: Wireless Card Access List Setup
4.
Click Add to add a wireless device to the wireless access control list. The Available Wireless
Cards list displays.
5. Select the Turn Access Control On check box.
6. Then, either select from the list of available wireless cards the WGT634U has found in your
area, or enter the MAC address and device name for a device you plan to use. You can usually
find the MAC address printed on the wireless adapter.
Note: You can copy and paste the MAC addresses from the Attached Devices menu into the
MAC Address box of this menu. To do this, configure each wireless computer to obtain a
wireless link to the router. The computer should then appear in the Attached Devices menu.
7. Click Add to add this wireless device to the Wireless Card Access List. The screen changes
back to the list screen. Repeat these steps for each additional device you want to add to the list.
8. Be sure to click Apply to save your wireless access control list settings.
Now, only devices on this list will be allowed to wirelessly connect to the WGT634U.
To Next Page
Loading...
