Wireless-G Router WGR614v10 Reference Manual
Safeguarding Your Network 2-2
v1.0, February 2010
Stronger security methods can entail a cost in terms of throughput, latency, battery consumption,
and equipment compatibility. In choosing an appropriate security level, you can also consider the
effort compared to the reward for a hacker to break into your network. As a minimum, however,
NETGEAR recommends using WEP with Shared Key authentication. Do not run an unsecured
wireless network unless it is your intention to provide free Internet access for the public.
WEP connections can take slightly longer to establish. Also, WEP, WPA-PSK, and WPA2-PSK
encryption can consume more battery power on a notebook computer, and can cause significant
performance degradation with a slow computer.
The Wireless-G Router provides two screens for configuring the wireless settings: the basic
Wireless Settings screen, which you access under Setup in the main menu (see “Changing Wireless
Security Settings” on page 2-6), and the Advanced Wireless Settings screen, which you access
under Advanced (see “Changing Wireless Security Settings” on page 2-6).
Basic security options are listed in order of increasing effectiveness in Table 2-1 below. Other
Note: NETGEAR recommends that you change the administration password of your
router. Default passwords are well known, and an intruder can use your
administrator access to read or disable your security settings. For information
about how to change the administrator password, see “Changing the Administrator
Password” on page 2-15.
Figure 2-1
WGR614v10
1) Open system: easy but no security
2) MAC access list: no data security
3) WEP: security but some performance
impact
4) WPA-PSK: strong security
5) WPA2-PSK: very strong security
Wireless data
security options
Range: up to 300 foot radius
Note: Use these with other features that enhance security (Table 2-2 on page 2-4).
To Next Page
Loading...
Need help?
General
