Extender Network Settings
18
Universal WiFi Range Extender WN2000RPT
4. Enter the encryption keys. You can manually or automatically program the four data
encryption keys. These values must be identical on all computers and access points in your
network:
• Passphrase. To use a passphrase to generate the keys, enter a passphrase, and
click Generate. This automatically creates the keys. Wireless computers must use
the passphrase or keys to access the extender.
Note: Not all wireless computers support passphrase key generation. If
your computer does not support the passphrase, then you will need
to type the encryption key in order to join the wireless network.
• Key 1–Key 4. These values are not case-sensitive. You can manually enter the four
data encryption keys. These values must be identical on all computers and access
points in your network. Enter 10 hexadecimal digits (any combination of 0
–9, a–f, or
A
–F).
5. Select which of the four keys will be the default.
Data transmissions are always encrypted using the default key. The other keys can be
used only to decrypt received data. The four entries are disabled if WPA-PSK or WPA
authentication is selected.
6. Click Apply to save your settings.
Extender IP Address Setup
Select extender Maintenance > IP Address to display the following screen:
The IP Address screen shows whether the extender is set to get its IP address dynamically
from the router (this is the most common setting), or is set as a static IP address.
• Get Dynamically From Router. The wireless network router assigns an IP address when
the extender connects to its wireless network. Most networks are set up so that the router
automatically does this.
To Next Page
Loading...
Need help?
General
