Hardware Setup
15
N600 Wireless Dual Band Router WNDR3400v3
Cable Your Router
The installation guide that came in the box has a cabling diagram on the first page.
Modem
DSL
or Cable
Internet
Ethernet cable ( ) to your MODEM, and
Step 2:
Connect one end of the yellow
and the other end to the Internet port
on your ROUTER.
Step 6:
Open a browser.
Step 4:
Step 3:
Plug in, then turn on your MODEM.
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
N600 Wireless Router
(not included)
Laptop or Desktop
Computer
N600 Wireless Router
Package Contents:
N600 Wireless Dual Band Router
WNDR3400v3
Installation Guide
Power adapter
Ethernet cable
If the web page doesn’t display,
close and re-open the browser to
http://routerlogin.net in the
address bar, or check the
“Troubleshooting” section on
the back of this installation guide.
(with stand attached)
Connect the power adapter to the
ROUTER, then plug it into an outlet.
Wait for the 2.4 GHz LED ( )
to turn on.
If none of the LEDs turn on, make sure the
Power On/Off button is in the ON position
(pushed in).
Attach the STAND to the ROUTER:
1. Position the router so that the Power
button is at the bottom and the USB
port is at the top.
2. Snap each piece of the stand onto a
bottom corner of the router.
2.4
GHz
Step 1:
Unplug the power
to turn off your MODEM.
Step 5:
Connect your computer
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using
the preset wireless security settings
located on the bottom label.
Router stand
(two pieces)
Power On/Off
to the ROUTER ( ).
ER:
er
B
a
Verify the Cabling
Verify that your router is cabled correctly by checking the router LEDs. Turn on the router by
pressing the On/Off button on the back.
• The Power/Test LED is green when the router is turned on.
•
The LAN ports are green for each PC cabled to the router by an Ethernet cable.
•
2.4
GHz
5
GHz
The Wireless LEDs are on.
•
The Internet LED is on. If it is not, make sure that the Ethernet cable is securely
attached to the router Internet port and the modem, and that the modem is powered on.
Verify that the LAN LEDs (1 through 4) are lit for any computers cabled to the router by
an Ethernet cable.
To Next Page
Loading...
Need help?
General
