NETGEAR WNR612

Netgear WNR612 Wireless Router User Manual
55
Click Add and the Block Services Setup page appears:
The following table describes parameters in this page:
Field Description
Service Type
Select a service type from the drop-down list. If your desired
type is not in the list, select User defined. Then, you need to
select the protocol, enter the service name, and specify the
port range. For services that exist in the drop-down list, the
corresponding information is already preset.
Protocol
Indicate the protocol that is used at the service ports. You can
select TCP/UDP, TCP, or UDP.
Starting Port
The first port to which an application sends a connection
request. All relevant ports can be open only after connection is
established at this starting port. Otherwise, other relevant ports
are not open.
Ending Port Set the end port of the service port range.
Service
Type/User
Enter the service name.