NETGEAR WNR612

Netgear WNR612 Wireless Router User Manual
79
The following table describes parameters in this page:
Field Description
Service Name Enter the service name.
Service User
You can select Any or Single address.
Any: Allow everybody in the user network to use the service.
Single address: Enter the IP address of the network card on
the PC. Then, the service is applied only on the specific
network card of the PC.
Service Type
Indicate the protocol used at the triggering port. You can select
TCP/UDP, TCP, or UDP.
Triggering
Port
Unless this port generates the traffic, the input connection service
cannot be triggered.
Connection
Type
You can select TCP/UDP, TCP, or UDP.
Starting Port
When the connection to the triggering port is successful, the
corresponding ports are open and the application can send
consequent connection request to the open ports.