User Manual for the NETGEAR RangeMax™ Wireless USB 2.0 Adapter WPN111
3-2 Basic Setup
202-10076-01
• Windows XP Home, Windows XP Professional, 2000. Some versions of Windows may ask for
the original Windows operating system installation files to complete the installation of the
WPN111 driver software.
Note: Windows XP users must install SP2 or install the KB822603 Hot fix which fixes the USB
2.0 Host controller driver. Go to the following link to install the Hot fix:
http://www.microsoft.com/downloads/
details.aspx?displaylang=en&FamilyID =733dd867-56a0-4956-b7fe-e85b688b7f86
Observing Location and Range Guidelines
Computers can connect over wireless networks indoors at a range which vary significantly based
on the physical location of the computer with the NETGEAR RangeMax™ Wireless USB 2.0
Adapter WPN111. For best results, avoid potential sources of interference, such as:
• Large metal surfaces
•Microwaves
• 2.4 GHz Cordless phones
In general, wireless devices can communicate through walls. However, if the walls are constructed
with concrete, or have metal, or metal mesh, the effective range will decrease if such materials are
between the devices.
Two Basic Operating Modes
The RangeMax™ WPN111 Wireless USB 2.0 Adapter can operate in the following two basic
modes:
•
Infrastructure Mode: An 802.11 networking framework in which devices and computers
communicate with each other by first going through an access point (AP). For example, this
mode is used when computers in a house connect to an Access Point that is attached to a router
which lets multiple computers share a single Cable or DSL broadband Internet connection.
•
Ad-Hoc Mode: An 802.11 networking framework in which devices or computers
communicate directly with each other, without the use of an AP. For example, Ad-Hoc Mode
is used when two Windows computers are configured with file and print sharing enabled and
you want to exchange files directly between them.
To Next Page
Loading...
Need help?
Wireless Specifications
