NETGEAR WPN111 User Manual

User Manual for the NETGEAR RangeMax™ Wireless USB 2.0 Adapter WPN111
4-2 Configuration
202-10076-01
For example, if you use your notebook PC to connect to a wireless network in an office and a
wireless network in your home, you can create a profile for each wireless network. Then, you can
easily load the profile that has all the configuration settings you need to join the network you are
using at the time.
There are two types of wireless network connections you can configure:
• Infrastructure Mode — uses the 802.11 infrastructure mode.
• Ad-hoc Mode — uses the 802.11 ad-hoc mode
For more information on 802.11 wireless network modes, see “Wireless Networking Overview”
on page B-1 of this manual.
Connecting to an Access Point in Infrastructure Mode
This section provides instructions for configuring the NETGEAR RangeMax™ Wireless USB 2.0
Adapter WPN111 to connect to a wireless access point.
How to Configure an Infrastructure Mode Profile
Follow the instructions below to configure an infrastructure mode profile for connecting to an
access point.
1. Run the WPN111 Configuration Utility.
a. Make sure the WPN111 software is installed and the WPN111 is connected to your PC.
b. Open the configuration utility by clicking on the WPN111 icon in the Windows system
tray.
c. Click on the Settings tab to display the view shown below.

NETGEAR WPN111 Specifications

Wireless Specifications

wireless speeds	1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54, 108 Mbps
frequency (US)	2.412 ~ 2.462 GHz
frequency (Japan)	2.412 ~ 2.472 GHz
frequency (Europe ETSI)	2.412 ~ 2.472 GHz
frequency (Spain)	2.457 ~ 2.462 GHz
frequency (France)	2.457 ~ 2.472 GHz

Physical Specifications

dimensions	94.5 x 30.2 x 15.2 mm
weight	32 g