Firmware Version:
(1)
Firmware version will be displayed by scanning “$SW#VER”.
Barcode Programming:
Netum barcode scanners are factory programmed for the most common
terminal and communication settings. If you need to change these settings,
programming is accomplished by scanning the bar codes in this guide. An
asterisk (*) next to an option indicates the default setting.
Connection Way
Scanner transmits data to your device via USB Dongle or USB cable. You can
choose either way to start scanning.
How to transmit data via 2.4G USB Dongle?
(1)Plug the USB dongle into your device(Wireless Transmit was set by default).
$SW#VER
Scanning the following barcode can restore the scanner to the factory defaults.
Factory Defaults
(2)Power On the scanner.
(3)Setup keyboard language: US keyboard was set by default. If you use other
type of keyboard please refer to Keyboard language.
Get Started:
To Next Page
Loading...
Need help?
General
