(2)
%#IFSN0$1
*Wireless Transmit
$USB#KEY
*USB HID-KBW
USB HID-KBW
When you connect scanner with your device via USB cable, USB HID-KBW
feature will be enabled by default. Scanner’s transmission will be simulated as
USB key-board input. It works on a Plug and Play basis and no driver is
required.
USB COM Port Emulation
When you connect scanner with your device via USB cable, by scanning “USB
COM Port Emulation” will allow your device to receive data in the way as a
serial port does.
Note: A driver is required for this feature.
$USB#COM
USB COM Port Emulation
How to transmit data via USB Cable?
(1)Plug one side of the USB cable into the bottom of scanner and plug the other
side into your device.
(3)Setup keyboard language: US keyboard was set by default. If you use other
type of keyboard please refer to Keyboard language.
To Next Page
Loading...
