10
5 SETTING UP THE FIREPLACE
Place the fireplace in its final position before continuing to
set up the fireplace.
Level the fireplace using the adjustable legs.
Once you have levelled the fireplace, it is strongly
recommended that you attach it to the wall using the wall
brackets for added stability and safety.
5.1 Flat Bottom Plate
The fireplace comes with a flat bottom plate. The bottom
plate can be removed by lifting it up and out of the
fireplace. Removing the bottom plate will allow easier
access to the junction box at the front of the fireplace
during installation. After the fireplace is wired reinstall the
bottom plate.
If the optional design bottom plates will be used the flat
bottom plate must be removed and replaced with the
design bottom plates.
5.2 (Optional) Placing Design Bottom Plates
Please note: If a flat bottom plate was chosen, this step can
be skipped.
The design bottom plates are made of fragile
material. Therefore, proceed with extreme
caution when installing the bottom plates.
Place the side plates into the fireplaces. Then place the
centre plate between the two side plates.
5.3 Installing Side Cover Plates
Install the two side cover plates into the fireplace. The
covers attach by magnets.
5.4 Installing Side L-Brackets
Install the side L-brackets by inserting the end of the bracket
into the slot at the back of the fireplace. Then rotate the
bracket down so that the end of the bracket fits into the slot
on the floor of the fireplace.
To Next Page
Loading...
Need help?
General
