13
5.6 Placing Glass Reflector
The glass reflector is susceptible to stains and fingerprints.
For this reason, always use the supplied gloves for
installation. To clean the glass reflector, follow the cleaning
instructions provided in the maintenance section of this
manual.
Remove the protective film from the glass reflector before
installing the reflector into the fireplace. Be carefull when
installing to not damage the glass.
The glass reflector installs into the fireplace with the
attached extrusion at the front with the notch in the
extrusion facing down. Slide the glass reflector into the
fireplace. The back of the glass will rest on a bracket at the
top of the fireplace. The extrusion at the front of the glass
will fit over the two studs protruding from the side of the L-
brackets.
5.7 Placing Post Covers
After the glass reflector is installed place the post covers at
the front corners of the glass. The post covers have cutouts
to fit between the extrusion on the glass and the L-brackets.
5.8 Placing Side Window
The side window glass slides into the glass holders on the
floor of the fireplace and in a channel at the top of the
fireplace. Open the front access panel by rotating it up.
Then slide the glass into the channel from the front.
To Next Page
Loading...
Need help?
General
