7 MAINTENANCE
PAGE
7.2R
Lubricating Oil:
text no.
R 07307-1/1
issued: 28.08.2015 Revision: 8
copy to:
*) It is not quite harmless if swallowed in more than minor quantities.
At a sudden break in a joint up to 470 ml of lubricating oil together with metal
rubbings may enter the pumping medium. It is therefore of essential importance to
regularly check the state of the joint seals and renew in time, if necessary.
If the pin joints operate without lubricating oil or seals, there will be no risk of
contaminating the medium with oil. This operation, however, results in a higher
amount of rubbed off metal parts through wear on the joints. These metal rubbings
will inevitably and continuously come into contact with the pumping medium.
Industrial application
Seal
material
Designation
according to
DIN 51502
Permitted Product
Food and Beverage
Industry only
FPM
EPDM
Authorized for use
in foodstuffs
- ”Gearfood”
VS 460
- “KLÜBER”
KLÜBERSYNTH UH1 6-460 *)
authorized under USDA H1
General Industry
FPM
NBR
- ”Gearfood”
PA 460
- ”EP”
EP 460
- “SHELL”
Omala 460
- “KLÜBER”
4UH1 460
EPDM
- ”Gearfood”
VS 460
- “KLÜBER”
KLÜBERSYNTH UH1 6-460 *)
CLP
460
CLP HC
460
CLP HC
460
IPP - EN - EN_07307_20150828/2 - D8411276 - 4300003998 - 000100 - NPS - 00229929 N 2018-02-21 19:03:25
To Next Page
Loading...
