Do you have a question about the NEUTRIK NL8FC speakON and is the answer not in the manual?
Place the bushing (1) and chuck (2) over the cable, noting specific bushing diameters.
Prepare the cable by stripping it to the specified length and noting the cable O.D. and wire size.
Insert wires into terminals and fasten the clamping device with a POZIDRIV® #1 screwdriver to 0.5 Nm.
Slide the chuck (1) onto the insert, aligning it by positioning the nose into the recess.
Slide the insert and chuck (1) into the housing (2), paying attention to the guiding keyway.
Fasten the bushing with a 1 1/16" (SW 27) fork wrench to a maximum torque of 3.5 Nm.
| Connector Type | speakON |
|---|---|
| Gender | Female |
| Number of Pins/Contacts/Poles | 8 |
| Mounting Type | Panel Mount |
| Contact Material | Brass |
| Housing/Insulation Material | Thermoplastic |
| Rated Voltage | 250 V |
| Operating/Temperature Range | -30 °C to +80 °C |
| IP Rating | IP54 |
| Contact Plating | Silver |
| Rated Current | 40 A |
| Dielectric Strength | 4kV |
| Wire Size | AWG 10 - 14 |
| Wiring | Screw terminals |
| Flammability | V-0 |
| Contact Resistance | <3mΩ |
| Insulation Resistance | >100MΩ |
| Lifetime | 1000 mating cycles |












Loading...