MANUAL PN 782389 REV 20230126MMF
Technical Service: 1-800-556-3926
10
ELECTRICAL HOOK-UP
WARNING: The brewer must be disconnected from the power source until specified in
Installation Instructions.
Determine the available on-site electrical requirements.
Refer to Data Plate on the brewer, and local/national electrical codes, to determine circuit
requirements.
CAUTION ā Improper electrical installation will damage electronic components.
BREWER SET UP INSTRUCTIONS
CX Touch battery eliminated units operate differently than older units that contain batteries
in the display tablet. It is no longer necessary or desirable to use the power switch on the
display tablet. The display tablet will power on and off with the brewer automatically. Note
that since the display tablet does not contain a battery, the tablet will go through a bootup
sequence whenever the brewer is powered on.
Note: This machine is designed to be run with power turned on at all times.
To Next Page
Loading...
