MANUAL PN 782389 REV 20230126MMF
Technical Service: 1-800-556-3926
28
OTHER SERVICE SCREENS
Hopper is empty, remove top cover of
machine, then hopper lid. Fill hopper with
appropriate powder up to red line.
This screen will only appear if powder
tracking is turned on.
Once hopper is removed to be refilled, the
“Please Replace [] Hopper” screen will show.
Waste Bin is full based on
Waste Bin Size set in
Programming Setup.
Screen will change to
“Please Replace Waste
Bin” once waste bin is
removed.
Waste Bin is not set in place
or has been removed.
Screen will disappear once
waste bin is replaced.
Note: Waste bin must be
removed for more than 5
seconds to reset pod count
Whipper bowl needs to
be rinsed.
Press rinse button inside
left door, under powder
product hoppers.
Once water runs clear,
release button and
screen will disappear.
Hopper is not set in place properly, or
hopper has been removed.
Screen will disappear once hopper is set
back in place.
To Next Page
Loading...
