21
Appendix A
Recycling and Separation Procedure
This section is used by the recycling center when the power meter reaches its end of life.
Breaking the calibration seal or opening the power meter enclosure will void the 1917-R
warranty.
The complete 1917-R power meter contains:
1 Hand-held power meter
4 AA Alkaline Batteries
1 9 volt AC/DC adaptor
1 CD User manual
1 Calibration certificate
Separation
Paper: Calibration certificate.
Plastic: CD, stand, connector plate, battery door, power meter enclosure, keypad.
Wires: inside power meter enclosure.
AA batteries: inside battery compartment.
Metal battery clips.
Printed circuit board: inside the power meter featuring a liquid crystal display less than 100 cm
2
.
Dismantling procedure:
- Remove batteries.
- Remove the posts on each side of the DB15 connector using pliers.
- Open power meter enclosure by removing the Phillips head screws in the 4 corners.
- Cut the wires on the PCB side and battery clips side with wire cutters.
- Remove battery clips with pliers.
To Next Page
Loading...
