Newport 1917-R User Manual

4
Safety Information
Do not use the 1917-R if the device or the detector looks damaged, or if you
suspect that the 1917-R is not operating properly.
Appropriate installation must be done for water-cooled and fan-cooled
detectors. Refer to the specific instructions for more information. The user
must wait for a while before handling these detectors after power is applied.
Surfaces of the detectors get very hot and there is a risk of injury if they are
not allowed to cool down.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, it is suggested to try to correct the interference by taking one or more
of the following steps:
 Reorient or relocate the receiving antenna.
 Increase the distance between the equipment and receiver.
 Connect the equipment to an outlet that is on a different circuit than the
receiver.
 Consult the dealer or an experienced radio/TV technician for help.

Newport 1917-R Specifications

General

Brand	Newport
Model	1917-R
Category	Measuring Instruments
Language	English