Nexo NXAMPmk2 Series User Manual

NXAMPMK2 USER MANUAL PAGE 51 / 80
ENERGY SAVER ENABLED
When enabled, the amplifier goes to Energy Saver Mode when no input signal has been received during a
given time interval. The power consumption is then reduced. When input signal is received again, the
amplifier leaves the Energy Save Mode.
No-signal time interval can be adjusted from 1 minute to 3 hours.
No-signal threshold level can be adjusted from -70 dBFS to  60 dBFS.
By default, Energy Saver Mode is disabled.
Energy saving measurements are available in Thermal Dissipation and Current Draw section.
DPU MODE
See DPU Digital Patching Unit for NXAMP section.
DEVICE INFORMATION
Displays some numeric information about the unit like Serial Number, Firmware, Main, Boot and Boot2
revision.

Nexo NXAMPmk2 Series Specifications

General

Brand	Nexo
Model	NXAMPmk2 Series
Category	Controller
Language	English