NexPump Ai2800 - Auto Notification; Normal and Critical Errors

VERIFY AUT
O NOTIFICA
TION IS INSTALLED:
1. Press Function Button Until ‘A’ appears (12 seconds).
2. Release Function Button.
3. Display shows revision number in the following format
‘x.xx.xxxx oooo’. The ‘x.xx.xxxx’ is the revision number and
the ‘oooo’ is any options installed.
4. If ‘Auto Notification’ is installed the option number will be
‘1xxx’. Only the first digit is applicable, if the number is a ‘0’
then ‘Auto Notification’ is not installed.
NORMAL
AND CRITICAL
ERRORS:
NORMAL ERRORS:
Alarm be silenced - See Function Button Operation
Auto Notification System:
When alarm is silenced the Notification System is postponed. If the
error continues when the 24 hour silence period expires, the alarm will
sound and Auto Notification will occur.
Pump Activated – (Backup mode Only)
Cleared by Function Button.
(If you do not want the alarm to sound or worry about the
Notification occurring after a silence period during a pro-
longed power outage. Simply switch the mode to primary.
This will no longer sound the alarm or Notify on pump activa-
tion. Remember to switch the mode back to backup.)
Input Power Off
This error is automatically reset when power is restored
CRITICAL
ERRORS:
Alarm can be disabled - See Function Button Operation
Battery Disconnected
Automatically reset when battery is connected.
Sensor disconnected
Automatically reset when sensor is connected.
Pump Problem
Cleared by Function Button.
Fan
Cleared by Function Button.
Plumbing Errors
Automatically reset if condition corrects itself.
Suspect Mode
Automatically reset if condition corrects itself.
Charge System Problem
Cleared by Function Button
Battery Replacement
Cleared by Function Button
Two Hours or Less Battery Life Remaining
Reset when electric is restored and battery charges
Errors will also scroll across the display every 15 seconds. Only one
error at a time will de displayed with an error count also being dis-
played each time.
16