This section will guide you through the installation of the NEXTBASE Replay software, designed to
enable the viewing of recorded files as well as checking journey route / GPS data (location and speed)
and G Sensor information.
Minimum system requirements:
Operating System: Windows XP, Vista, Windows 7, Windows 8, Windows 10
Processor (CPU): Pentium III 500 MHz or Celeron at 800 MHz
Memory: 1 GB RAM
Storage: 100Mb Internal hard drive space
CD-ROM Drive: Tray / Slot Loader
Monitor/Display: 1280 x 1024
Windows NEXTBASE Replay:
Insert the supplied disk in to the CD drive, navigate to and display the contents upon the disk:
- NBDVR512G Instruction Manual (English only)
- NBDVR512G NEXTBASE Replay Software for Windows
- NBDVR512G NEXTBASE Replay Software for Mac
Note:
- The instruction manual and installation files are also available for download from the Nextbase UK
website: www.nextbase.co.uk, if required.
Should you experience any difficulties during installation please do not hesitate to
call our English speaking technical support team on +44 (0)2920 866429,
lines are open during normal business operating hours: 09:00-17:30hrs.
NEXTBASE REPLAY SOFTWARE FOR WINDOWS
25
02/06/2015 15:35:44 NBDVR512G 29MPH N 51 35 4.92 W 3 13 14.87
VIEW
HELP
Z: 1.05 MAX: 1.2
To Next Page
Loading...