19
Resolution
Change your Dash Cam’s recording resolution
Options: 1440P @ 30FPS (frames per second), 1080P @ 60FPS, 1080P @ 30FPS
Default: 1440P @ 30FPS
The resolution of an attached Rear Facing Camera is dictated by the chosen resolution of the
Front Facing camera. The resolution of the Rear Camera cannot be altered independently of the
resolution of the Front Camera; the two resolutions are linked together to ensure maximum
performance. See the table below for the Rear Camera resolutions:
Exposure
Adjust the exposure level for different lighting conditions.
Options: Values range from -6 to +6
Default: 0
Video Length
Set the length of the individual recorded video files. The Dash Cam will continue recording, filling
the memory card. When the memory card becomes full, the oldest file will be automatically
deleted to make space for the new recording.
Old Protected Files can be overwritten; back up important files as soon as possible to avoidNote:
losing your footage. See page 6 for more details.
Options: 1 minute, 2 minutes, 3 minutes
Default: 1 minute
Audio
Turn On/Off the microphone for video recording.
Options: On and Off
Default: On
Time Stamp
Turn On/Off the time and date stamp shown on recorded files.
Options: On and Off
Default: On
Menus
Press the ‘Menu’ button (top left of the Dash Cam display) to enter the Dash Cam’s menu system.
1
2
3
4
Video Settings:
- Resolution
- Exposure
- Video Length
- Audio
- Time Stamp
- Speed Stamp
- GPS Stamp
- Model Stamp
- Dual Files
- Time lapse
- Number Plate
- G Sensor
Setup:
- Screen Saver
- Alerts
- Recording History
- Parking Mode
- Language
- Country
- Time Zone / DST
- Time & Date
- Speed Units
- Device Sounds
- Screen Dimming
- Auto Power Off
- Keep User Settings
- System Info
- Format SD Card
- Default Settings
Driver Assistance:
- Emergency SOS
- Reversing Camera
Connected Apps:
- MyNextbase
- Alexa
Resolution
Front Camera
Rear Camera (if connected)
1440P @ 30FPS
1080P @ 30FPS
1080P @ 60FPS
720P @ 30FPS
1080P @ 30FPS
720P @ 30FPS
Connect Apps
Video Settings
The default settings have been carefully selected to allow you to use your Dash Cam
without the need to change any settings. However, should you wish to change a setting then
please see below:
- Use the touch screen to select a settings submenu
(Video Settings, Setup, Driver Assistance, Connect Apps)
- Once in the submenu, use the touchscreen to select which function to change.
- When swiping through the menu pages, swipe from the middle of the screen, to avoid accidentally
selecting a submenu/function.
Notes:
- Menus are not accessible whilst the Dash Cam is recording.
- Within the Setup Menu there is a ‘Default Settings’ option to allow you to reset the Dash Cam
to the factory defaults, if required.
Menu Tree:
See below for the settings to be found under each submenu:
5
To Next Page
Loading...
Need help?
General
Weight and Dimensions
