JAN 2024 Page | 12
Boot Up:
Once the power is connected, the LEDs will flash. The system may take a few minutes to boot up.
During that time the PWR LED should remain lit. When the unit is successfully connected, the
“INTERNET” LED will show a solid green light.
Refer to Section 1.3 ‘SHIELD MegaFi LEDs’ for further information.
2.3 Mobile Kit: Vehicle or Mobile Installation
Note: Installing and activating a SHIELD MegaFi router in your vehicle is straightforward for those
familiar with installing other after-market antenna-connected systems. If you are planning a self-
installation and are not a professional, it is recommended that you seek guidance from someone with
hands-on experience with similar products. For help locating an expert installer, contact Nextivity support
at support@nextivityinc.com
.
There is an installation video located at https://go.nextivityinc.com/megafi-mobile-installation-guide that
may assist in providing an overview of the steps to a successful vehicle installation.
Below are detailed steps for the Mobile MegaFi kit.
Required Hardware and Tools:
Note: Nextivity does not provide screws or other hardware that may be needed to secure the MegaFi and
related components as installation varies widely depending on how and where in the vehicle the system
is installed.
1) Screwdriver or other hand/power tools as needed
2) Hardware for installation
To Next Page
Loading...