Need help?Do you have a question about the Nexus AUTOPILOT and is the answer not in the manual?
General| Brand | Nexus |
|---|---|
| Model | AUTOPILOT |
| Category | Marine Equipment |
| Language | English |
Overview of the Nexus Autopilot's key features, accuracy, reliability, and simplicity of use.
Explains how the Autopilot maintains course by comparing set and actual heading and adjusting rudder.
Details the essential hardware components of the Nexus Autopilot system.
Procedure for setting up instruments and assigning logical ID numbers on the Nexus Network.
Steps to resolve network issues caused by duplicate instrument ID numbers.
Describes the Autopilot instrument's display layout, pages, functions, and modes.
Explains the function of each push-button for mode selection, course adjustment, and setup.
Operates as a passive compass repeater when Autopilot is off.
Details automatic steering by compass, navigator, wind, plus power steering and dodging.
How to access, navigate, and change settings within the setup mode.
Configuration settings for Autopilot performance parameters like rudder control and damping.
Settings for various audible and visual alarms, including course and timer alarms.
Settings for compass calibration, variation, and auto-deviation correction.
Guidelines for cleaning and maintaining the Autopilot instrument.
Schedule and procedures for maintaining hydraulic and mechanical drive units.
Common installation issues that can cause faults in the Autopilot system.
Troubleshooting guide for common Autopilot symptoms and their remedies.
Lists and explains error messages from the Nexus Network and their resolutions.
Detailed technical data for the Autopilot instrument, servo units, and transmitter.
Information on the Nexus Network capabilities and available optional accessories.
Essential steps and precautions for a successful Autopilot installation.
Instructions for locating and mounting the main Autopilot instrument.
Mounting the Servo Unit, its connections, dip switches, and related components.
Steps for mounting and connecting the rudder angle transmitter to the steering system.
Information on installing linear drives and solenoid valve controlled pumpsets.
Steps before and during the initial power-up and system check.
Procedure for purging air from the hydraulic steering system.
Steps for preparing for sea trials and calibrating the compass system.
The essential routine for the Autopilot to learn boat characteristics and calibrate itself.
Step-by-step guide to fine-tune Autopilot settings for optimal boat control.
To Next Page
