Caution
Night cooling can only be activated when house heating has been deac-
tivated. This is done in menu 4.2.
+Adjust
- degree of effect
Setting range: 0.1 – 1.0
Default value: 0.5
Menu
1.9.11
Using +Adjust, the installation communicates with the underfloor heating's
control centre* and adjusts the heat curve and calculated supply temper-
ature according to the underfloor heating system's reconnection.
Here you can activate the climate systems you want +Adjust to affect. You
can also set how much effect +Adjust is to have on calculated supply
temperature. The higher the value, the greater the effect.
*Support for +Adjust required
NOTE
+Adjust must first be selected in menu 5.4 ”soft inputs/outputs”.
NIBE™ F1155Chapter 3 | F1155 – at your service46
To Next Page
Loading...
