Nibe F1226 - Page 50

op. prioritisation
RS SULRULWLVDWLRQ 
PLQ
PLQ
KRW ZDWHU
KHDWLQJ
op. prioritisation
Setting range: 0 to 180 min
Default value: 20 min
Choose here how long the heat pump should work with each requirement
if there are two or more requirements at the same time. If there is only one
requirement the heat pump only works with that requirement.
The indicator marks where in the cycle the heat pump is.
If 0 minutes is selected it means that requirement is not prioritised, but will
only be activated when there is no other requirement.
Menu
4.9.1
NIBE™ F1226Chapter 3 | F1226 – at your service48