Nibe S1155 - Menu 5 - Connection

Menu 5 - Connection
OVERVIEW
5.1 - myUplink
5.2.1 - wifi5.2 - Network settings
5.2.2 - Ethernet
5.4 - Wireless devices
MENU 5.1 - MYUPLINK
Here you can manage the installation's connection to
myUplink (myuplink.com) and see the number of users
connected to the installation via the internet.
A connected user has a user account in myUplink ,
which has been given permission to control and/or
monitor your installation.
Request new connection string
To connect a user account on myUplink to your installa-
tion, you must request a unique connection code.
1.
Select "Request new connection string"
2.
The installation now communicates with myUplink
to create a connection code.
3.
When a connection string has been produced, it is
shown in this menu and is valid for 60 minutes.
Disconnect all users
To disconnect the users who are connected to the in-
stallation via myUplink, select "Disconnect all users".
NOTE
After disconnecting all users none of them can
monitor or control your installation via myUplink
without requesting a new connection string.
MENU 5.2 - NETWORK SETTINGS
Here, you choose whether your system connects to the
Internet via wifi (menu 5.2.1) or via a network cable
(Ethernet) (menu 5.2.2).
TCP/IP settings
You can set TCP/IP settings for your installation here.
Automatic setting (DHCP)
Activate "Automatic". The installation now receives the
TCP/IP settings using DHCP.
Manual setting
Select "IP address" and enter correct address using the
keyboard.
Repeat the procedure for "Network mask", "Gateway"
and "DNS".
Caution
The installation cannot connect to the internet
without the correct TCP/IP settings. If unsure
about applicable settings use the automatic
mode or contact your network administrator
(or similar) for further information.
TIP
All settings made since opening the menu can
be reset by selecting "Reset".
MENU 5.4 – WIRELESS DEVICES
Here, you connect your wireless units. Follow the guide
that starts.
A zone is created automatically when you connect a
new wireless room sensor. (Default setting: One zone
per climate system.)
When you decide to create additional zones, you select
a name as well as the climate system to which the zone
will belong.
If you add a radiator thermostat, you will have the option
of selecting an existing zone or creating a new zone.
NIBE S1155Chapter 9 | Control - Menus50