Nibe S1155 - Menu 7 - Service

Menu 7 - Service
OVERVIEW
7.1.1.1 - Temperature setting7.1.1 - Hot water
7.1 - Operating settings
1
7.1.1.2 - Operating settings
7.1.2.1 - Operating mode, heating medi-
um pump
1
7.1.2 - Circulation pumps
7.1.2.2 - Pump speed, heating medium
1
7.1.2.6 - Operating mode, brine pump
1
7.1.2.7 - Pump speed brine
1
7.1.2.8 - Brine alarm settings
7.1.3.1 - Block freq7.1.3 - Compressor
7.1.4.1 - Fan speed, exhaust air
2
7.1.4 - Ventilation
2
7.1.4.2 - Fan speed, supply air
2
7.1.4.3 - Ventilation adjustment
2
7.1.5.1 - Internal electric additional heat7.1.5 - Additional heat
7.1.6.1 - Max diff. supply temperature7.1.6 - Heating
7.1.6.2 - Flow setting, climate system
7.1.6.3 - Power at DOT
7.1.8.1 - Alarm actions7.1.8 - Alarm
7.1.8.2 - Emergency mode
7.1.9 - Load monitor
7.1.10.1 - Operating priority7.1.10 - System settings
7.1.10.2 - Auto mode setting
7.1.10.3 - Degree minutes setting
7.2.1 - Add/remove accessories
7.2 - Accessory settings
2
7.2.19 - External energy meter
7.3.1 - Configure7.3 - Multi-installation
7.3.2 - Installed heat pump
7.3.3 - Name heat pump
7.3.4 - Docking
7.4 - Selectable in/outputs
7.5.1.1 - Test mode7.5.1 - Heat pump, test7.5 - Tools
7.5.2 - Underfloor drying function
7.5.3 - Forced control
7.5.6 - Inverter replacement
7.5.8 - Screen lock
7.5.9 - Modbus TCP/IP
7.6 - Factory setting service
7.7 - Start guide
7.8 - Quick start
7.9.1 - Change log7.9 - Logs
7.9.2 - Extended alarm log
7.9.3 - Black box
1
This menu is also shown in the subordinate heat pump’s limited menu system.
2
Consult the accessory’s Installer Manual.
NIBE S1155Chapter 9 | Control - Menus52